Technical Resource

Anionic vs Nonionic Dispersants: How to Choose

Updated Oct 18, 2026

Anionic vs Nonionic Dispersants: How to Choose

Anionic dispersants stabilise particles mainly by negative charge (electrostatic repulsion); nonionic dispersants stabilise mainly by bulky water-loving chains (steric hindrance). Anionic types such as lignosulfonates and naphthalene sulfonate condensates work well in water at moderate salt levels and are economical; nonionic types such as alcohol ethoxylates tolerate high electrolyte and work across pH, but are sensitive to temperature (cloud point).

Comparison

PropertyAnionic dispersantsNonionic dispersants
Stabilising mechanismElectrostatic repulsion from adsorbed negative chargesSteric hindrance from hydrated polymer chains
ExamplesSodium lignosulfonate, Dispersant NNO, Dispersant MF, alkyl naphthalene sulfonates (wetting)Alcohol ethoxylates (AEO), alkyl polyglucosides (APG), EO/PO block copolymers
Salt and hardnessCharge is screened at high salt; sulfonates tolerate hard water better than carboxylatesLargely insensitive to salt
TemperatureGenerally stableEthoxylates lose water solubility above the cloud point
pH rangeSulfonates work across a wide pH rangeWide pH range
FoamCondensates and lignosulfonates are low-foamingVaries; many ethoxylates foam
CompatibilityNot compatible with cationic surfactantsCompatible with anionic and cationic systems
CostUsually lowerUsually higher

How to Choose

  • Water-based dye, pigment and agrochemical suspensions: start with an anionic dispersant; add a nonionic if electrolyte is high or storage stability is short.
  • High-salt systems (brines, some fertiliser suspensions): nonionic or polymeric steric dispersants, or sulfonated anionics tested at the real salt level.
  • Systems with cationic components: use nonionic dispersants; anionics will interact with cationics.
  • Hot processes: check the cloud point of nonionics; anionics are usually safer.
  • Wetting vs dispersing: small anionics such as alkyl naphthalene sulfonates wet powders; condensates and lignosulfonates disperse. Many formulations use both.

Quick Lab Screening

  • Prepare the same slurry with each dispersant at 2โ€“3 levels.
  • Measure viscosity and particle size after milling.
  • Check sedimentation after 24 h and after heat storage.
  • Repeat in hard water or at the real salt level.
  • For charged systems, zeta potential shows how strongly an anionic dispersant charges the particles.

Frequently Asked Questions

What is the main difference between anionic and nonionic dispersants?

Anionic dispersants work mainly by giving particles a negative charge so they repel each other; nonionic dispersants work mainly by forming a hydrated layer that keeps particles apart physically.

Are lignosulfonates anionic or nonionic?

Anionic. Their sulfonate and carboxyl groups carry negative charges in water.

Can anionic and nonionic dispersants be combined?

Yes, and they often are. The combination can give both electrostatic and steric stabilisation.

Questions about a specification, a test method or a trial: contact us or email info@greenagrochem.com.